Filter
Top Products
•
•
•
•
•
Appendix
38
4
In the command-line text box,
type the letter of your disk
drive, followed by
:\setup
(for
example,
a:\setup
), and then
click
OK
.
5
When prompted by the printer
software, insert the appropriate
disks into your disk drive and
click
OK
.
6
Follow the instructions on the
screen.
Ordering Diskettes
If your computer does not have a
CD-ROM drive, and you do not
have access to either the World
Wide Web or a computer with a
CD-ROM drive, you can order
diskettes from our Technical
Support Center.
Uninstalling printer
software
If your printer software does not
install properly, or your printer port
is not set to the correct port, you
may need to uninstall, and then
reinstall your printer software.
To uninstall the printer software:
1
From the
Start
menu, select
Programs
.
2
Select
Compaq IJ1200
.
3
Select
Compaq IJ1200
Uninstall
.
4
Follow the instructions on your
screen.
To reinstall the printer software
following the instructions from
“Installing printer software” on
page 37.
Printing from DOS
DOS printing is only available
when your printer is connected to
your personal computer with a
parallel cable.
To open your printer online Help
system and find information on
printing from DOS:
1
Open the Printer Properties (for
help, see page 5) or the Control
Program (for help, see
page 21).
2
Click the
Help
button in the
lower-right corner of the
software screen.
3
At the top of the Help screen,
click
Help Contents
.
4
Scroll down the screen to
How
to...
.
5
From the How to... topics, click
Print from Windows and
DOS applications
.
Notices
Federal Communications
Commission (FCC)
Compliance Information
Statement
This equipment has been tested
and found to comply with the
limits for a Class B digital device,
pursuant to Part 15 of the FCC
Rules. Operation is subject to the
following two conditions: (1) this
device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference
that may cause undesired
operation.
The FCC Class B limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can
be determined by turning the
equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the
following measures:
•
Reorient or relocate the
receiving antenna.
•
Increase the separation
between the equipment and
receiver.
•
Connect the equipment into an
outlet on a circuit different
from that to which the receiver
is connected.
•
Consult your point of purchase
or service representative for
additional suggestions.
The manufacturer is not
responsible for any radio or
television interference caused by
using other than recommended
cables or by unauthorized changes
or modifications to this equipment.
Unauthorized changes or
modifications could void the user's
authority to operate this
equipment.
To assure compliance with FCC
regulations on electromagnetic
interference for a Class B
computing device, use a properly
shielded and grounded cable. Use
of a substitute cable not properly