Filter
Top Products
5–20 Maintenance and Service Guide
Removal and Replacement Procedures
3. Lift the front edge of the heat sink and swing it up and back
until the shield rests at a 45-degree angle
1
(Figure 5-13).
4. Pull the heat sink away from the base enclosure at a
45-degree angle
2
and remove it from the base enclosure.
Figure 5–13: Removing the Heat Sink
A thermal pad
3
is installed on the heat sink and makes contact
with the processor. Any time the heat sink is removed, inspect the
thermal pad for damage.
238850-003.book Page 20 Friday, December 21, 2001 2:53 PM