Filter
Top Products
Modem module
Description Spare part number
High-speed 56K modem for use in all countries and regions except Australia and New Zealand
(for models 1.0 and 1.1 only)
510100-001
High-speed 56K modem for use in Australia and New Zealand (for models 1.0 and 1.1 only) 510100-011
Modem module cable with RJ-11 connector (included in the cable kit) 610791-001
Before removing the modem module, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 52).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 53)
b. Optical drive (see
Optical drive on page 56)
c. Keyboard (see
Keyboard on page 63)
d. Top cover (see
Top cover on page 65)
Remove the modem module:
1. Turn the computer upright with the front toward you.
2. Remove the two Phillips PM2.0×3.0 screws (1) that secure the modem module to the system
board.
3. Disconnect the modem module cable (2) from the modem module.
ENWW Component replacement procedures 71