Filter
Top Products
3. Release the optical drive cable (1) from the system board.
4. Lift the right side of the system board (2).
5. Release the system board by sliding it to the right at an angle (3) until the connectors on the left
side of the system board clear the base enclosure, and then remove the system board.
6. If it is necessary to replace the modem module cable, remove the RJ-11 connector (1) from the
clip built into the base enclosure.
7. Remove the modem module cable (2) from the routing channel built into the base enclosure.
The modem module cable is available using spare part number 610791-001.
ENWW Component replacement procedures 85