Filter
Top Products
. . . . . . . . . . . . . . . . . . . . . . . . .
Using Battery Packs 4-5
Writer: Betty Fessenden - Saved by: BLF - Saved date: 6/15/96
Part Number: 213660-001 - File name: CH4
Replacing Battery Pack(s)
If you are operating the computer with only one battery pack or if
the computer indicates a low-battery condition, initiate Suspend
before replacing the battery pack(s).
CAUTION: To prevent loss of unsaved data when the computer is on
and you are removing the only battery pack, initiate Suspend. When the
screen blanks and the power/suspend light begins blinking, remove the
battery pack and replace it with a charged battery pack within ten
minutes.
If you are operating the computer with two battery packs and the
computer is not in a low-battery condition, you can remove one
battery pack without first initiating Suspend.
Removing a Battery Pack from the Computer
1. If you are operating the computer with only one battery pack or
if a low-battery condition exists, press the suspend button
➊.
(The screen blanks, the power/suspend light blinks, and the
status panel turns off.)
2. Pull forward on the battery release on the right side of the
computer
➋ to release the battery pack in the dedicated battery
compartment.
NOTE: To release a battery pack in the MultiBay, pull forward
on the MultiBay device release on the left side of the computer.
3. Remove the battery pack
➌.