Filter
Top Products
Removal and Replacement Procedures
Maintenance and Service Guide 5–51
5. Remove the three TM2.5 × 5.0 screws
1
that secure the top
cover to the base enclosure (Figure 5-40).
6. Lift the top cover straight up
2
approximately one inch, then
slide it forward
3
until the microphone cable
4
is exposed.
7. Disconnect the microphone cable
5
from the system board.
8. Remove the microphone
6
from the top cover.
9. Remove the top cover from the base enclosure.
Figure 5-40. Removing the Top Cover and Microphone
✎
The microphone is included in the Miscellaneous Cable Kit,
spare part number 285540-001.
279372-001.book Page 51 Friday, July 19, 2002 11:50 AM