Filter
Top Products
76 user’s guide
hardware installation (continued)
Symptom Problem Solution
New or existing device does
not work after installing a
new device.
A hardware device conflict
exists.
To resolve a device conflict, you may need to disable one
of the devices or uninstall an old device driver.
1 Click Start and choose Control Panel.
2 Click Performance and Maintenance, if it is
present.
3 Double-click the System icon and select the
Hardware tab.
4 Click the Device Manager button.
5 Click the + (plus) symbol next to the problem device
and check for exclamation points in a yellow circle near
the device icon. The exclamation point means there is a
device conflict or problem with the device. Exclamation
points do not always appear when a device is not
working properly.
6 If there is an old or unnecessary device driver listed in
the Device Manager, this may be causing the device
conflict. To uninstall the old driver for the new device
driver to work properly, do the following: Right-click the
device, click Uninstall, and then click OK.
7 Right-click the device and select Properties.
8 If available, click the Resources tab to verify that there
is a device conflict.
9 Click the General tab to see if your device is enabled
and working properly. If it is available, click the
Troubleshoot button and follow the onscreen
instructions in the device troubleshooter wizard.
10 Restart the PC. Click Start, click Turn Off Computer,
and then click Restart.
internet access
Symptom Problem Solution
Internet Service Provider
(ISP) account is not set up
properly.
Verify Internet settings, or contact your ISP for assistance.
Modem is not set up
properly.
Reconnect the modem, verifying connections; see page 7.
Note that your PC may also have an Ethernet network
interface (also called a network interface card, or NIC) that
connects to a LAN (Local Area Network). Although it looks
similar to the modem connector, the RJ-45 Ethernet network
connector is not the same. Verify that you are using the
modem connector. Do not connect a telephone cable to the
NIC. Do not plug a network cable into a telephone service
line; doing so may damage the NIC.
Cannot connect to the
Internet.
Web browser is not set up
properly.
Verify that the Web browser is installed and set up to work
with your ISP.