Filter
Top Products
Power on
RP90 Plus E and RL90 User Guide 15
Power on the printer
1 Press the “|" symbol on the
power switch.
2 The printer powers on. The
LCD panel shows the firmware
version and the printer begins
initializing. The LCD panel
shows "Initializing" while the
printer checks and positions
the ink ribbon and retransfer
film.
3 When operation checks are
complete, "Preheating" is
displayed on the LCD panel for
approximately four minutes while the retransfer roller and bend remedy
roller warm to their operating temperatures.
4 The LCD panel shows "Ready" and the Ready Light is steady green.
5 The first time you print cards, initialize the ink ribbon. See “Initialize
the ink ribbon” on page 16
for the steps to follow.
6 The first time you print cards, set and initialize the retransfer film. See
“Set the retransfer film type” on page 16 and “Initialize the
retransfer film” on page 17
for the steps to follow.
LCD sequence on printer startup
The printer can require up to 4 minutes between power-on and the “Ready”
status.
Tips for printer power
• To avoid receiving errors
on the LCD panel, make
sure that all supplies are
properly loaded and in
position before powering
on the printer.
• Wait while the printer
initializes.
• Follow the guidelines for
your organization about
when to power the
printer on and off.