Filter
Top Products
46
CHAPTER 5: INSTALLING ADDITIONAL OR REPLACEMENT COMPONENTS
1
2
4
3
5
1 memory module connector 4 spring locks (2)
2 notch 5 memory module
3 tab
To replace the memory modules, perform the removal steps in reverse order.
While inserting the memory module into the connector align the notch on the
memory module to the tab on the memory module connector.
NOTE: Install the memory module rst in the bottom connector and then
in the top connector.
NOTE: If the memory module is not installed properly, the computer may
not boot.
Loosen the two captive screws and remove the memory module door.3.
2
1
1 memory module door 2 captive screws (2)
Use your ngertips to carefully spread apart the memory module 4.
connector’s spring-locks until the module pops up.
Remove the memory module.5.