Filter
Top Products
Back to Contents Page
Display Assembly
Dell™Inspiron™8500/8600ServiceManual
Display Assembly
Display Bezel
Display Panel
Display Assembly
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Turn the computer over and remove the two M2.5 x 12-mm screws labeled "D" on the bottom of the computer.
3. Turn over the computer and open the display.
4. Remove the central control cover.
5. Disconnect the display cable using the pull-tab, and release the cable from the four cable-routing clips.
6. Lift the display out of the computer.
CAUTION: Before performing the following procedures, read the safety instructions in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm rest.
NOTE: When you replace the display assembly, ensure that you route the display cable under the EMI clip and cable-routing clips.