Filter
Top Products
Back to Contents Page
Display Assembly and Display Latch
Dell™ Latitude™ C400 Service Manual
Removing the Display Assembly
Replacing the Display Latch
Removing the Display Assembly
NOTICE: You must remove the display assembly before you remove the palm rest.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed
batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on
the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing the following procedure.
1. Remove the battery.
2. Remove the hard drive.
3. Remove the center cover
.
4. Close the display.
5. Turn the computer over and remove the two M2.5 x 6-mm screws at the bottom back corners of the computer.
Display Screws
1 M2.5 x 6-mm screws (2)
6. Turn the computer right-side up and open the display 180 degrees.