Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 1125
53-1002266-01
Displaying VRRP and VRRPE information
31
Syntax: show ip vrrp-extended brief | ethernet [<slotnum>/]<portnum> | ve <num> | stat
The brief parameter displays summary information. Refer to “Displaying summary information” on
page 1122.
The <portnum> parameter specifies an Ethernet port. If you use this parameter, the command
displays VRRP or VRRPE information only for the specified port. Also, you must specify the
<slotnum> on chassis devices.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command
displays VRRP or VRRPE information only for the specified virtual interface.
The stat parameter displays statistics. Refer to “Displaying statistics” on page 1128.
This display shows the following information.
TABLE 196 CLI display of VRRP or VRRPE detailed information
This field... Displays...
Total number of VRRP (or
VRRP-Extended) routers defined
The total number of VRIDs configured on this Layer 3 Switch.
NOTE: The total applies only to the protocol the Layer 3 Switch is running. For
example, if the Layer 3 Switch is running VRRPE, the total applies only
to VRRPE routers.
Interface parameters
Interface The interface on which VRRP or VRRPE is configured. If VRRP or VRRPE is
configured on multiple interfaces, information for each interface is listed
separately.
auth-type The authentication type enabled on the interface.
VRID parameters
VRID The VRID configured on this interface. If multiple VRIDs are configured on the
interface, information for each VRID is listed separately.
state This Layer 3 Switch VRRP or VRRPE state for the VRID. The state can be one of
the following:
• initialize – The VRID is not enabled (activated). If the state remains
“initialize” after you activate the VRID, make sure that the VRID is also
configured on the other routers and that the routers can communicate
with each other.
NOTE: If the state is “initialize” and the mode is incomplete, make sure you
have specified the IP address for the VRID.
• backup – This Layer 3 Switch is a Backup for the VRID.
• master – This Layer 3 Switch is the Master for the VRID.
administrative-status The administrative status of the VRID. The administrative status can be one of
the following:
• disabled – The VRID is configured on the interface but VRRP or VRRPE
has not been activated on the interface.
• enabled – VRRP or VRRPE has been activated on the interface.
mode Indicates whether the Layer 3 Switch is the Owner or a Backup for the VRID.
NOTE: If “incomplete” appears after the mode, configuration for this VRID is
incomplete. For example, you might not have configured the virtual IP
address that is being backed up by the VRID.
NOTE: This field applies only to VRRP. All Layer 3 Switches configured for
VRRPE are Backups.