Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 1151
53-1002266-01
Setting passwords
32
PowerConnect#configure terminal
PowerConnect(config)#
3. Enter the following command to set the Super User level password.
PowerConnect(config)#enable super-user-password <text>
NOTE
You must set the Super User level password before you can set other types of passwords. The
Super User level password can be an alphanumeric string, but cannot begin with a number.
4. Enter the following commands to set the Port Configuration level and Read Only level
passwords.
PowerConnect(config)#enable port-config-password <text>
PowerConnect(config)#enable read-only-password <text>
Syntax: enable super-user-password <text>
Syntax: enable port-config-password <text>
Syntax: enable read-only-password <text>
NOTE
If you forget your Super User level password, refer to “Recovering from a lost password” on
page 1152.
Augmenting management privilege levels
Each management privilege level provides access to specific areas of the CLI by default:
• Super User level provides access to all commands and displays.
• Port Configuration level gives access to:
• The User EXEC and Privileged EXEC levels
• The port-specific parts of the CONFIG level
• All interface configuration levels
• Read Only level gives access to:
• The User EXEC and Privileged EXEC levels
You can grant additional access to a privilege level on an individual command basis. To grant the
additional access, you specify the privilege level you are enhancing, the CLI level that contains the
command, and the individual command.
NOTE
This feature applies only to management privilege levels on the CLI. You cannot augment
management access levels for the Web Management Interface.
Enhance the Port Configuration privilege level so users also can enter IP commands at the global
CONFIG level.
PowerConnect(config)#privilege configure level 4 ip