Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 1247
53-1002266-01
Displaying 802.1X information
34
Enabling 802.1X accounting
To enable 802.1X accounting, enter the following command.
PowerConnect(config)#aaa accounting dot1x default start-stop radius none
Syntax: aaa accounting dot1x default start-stop radius | none
radius – Use the list of all RADIUS servers that support 802.1X for authentication.
none – Use no authentication. The client is automatically authenticated without the device using
information supplied by the client.
NOTE
If you specify both radius and none, make sure radius comes before none.
Displaying 802.1X information
You can display the following 802.1X-related information:
The 802.1X configuration on the device and on individual ports
Statistics about the EAPOL frames passing through the device
802.1X-enabled ports dynamically assigned to a VLAN
User-defined and dynamically applied MAC address filters and IP ACLs currently active on the
device
The 802.1X multiple-host configuration
Displaying 802.1X configuration information
To display information about the 802.1X configuration on the Dell PowerConnect device, enter the
following command.
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
PowerConnect#show dot1x
PAE Capability: Authenticator Only
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period: 60 Seconds
tx-period: 30 Seconds
supptimeout: 30 Seconds
servertimeout: 30 Seconds
maxreq: 2
re-authperiod: 3600 Seconds
Protocol Version: 1