Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
1248 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying 802.1X information
34
To display information about the 802.1X configuration on an individual port, enter a command such
as the following.
TABLE 212 Output from the show dot1x command
This field... Displays...
PAE Capability The Port Access Entity (PAE) role for the Dell PowerConnect device. This is always
“Authenticator Only”.
system-auth-control Whether system authentication control is enabled on the device. The
dot1x-enable command enables system authentication control on the device.
re-authentication Whether periodic re-authentication is enabled on the device. Refer to
“Configuring periodic re-authentication” on page 1239.
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
global-filter-strict-security Whether strict security mode is enabled or disabled globally. Refer to “Disabling
and enabling strict security mode for dynamic filter assignment” on page 1235.
quiet-period When the Dell PowerConnect device is unable to authenticate a Client, the
amount of time the Dell PowerConnect device waits before trying again (default
60 seconds).
Refer to “Setting the quiet period” on page 1240 for information on how to
change this setting.
tx-period When a Client does not send back an EAP-response/identity frame, the amount
of time the Dell PowerConnect device waits before retransmitting the
EAP-request/identity frame to a Client (default 30 seconds).
Refer to “Setting the wait interval for EAP frame retransmissions” on page 1240
for information on how to change this setting.
supp-timeout When a Client does not respond to an EAP-request frame, the amount of time
before the Dell PowerConnect device retransmits the frame.
Refer to “Setting the wait interval for EAP frame retransmissions” on page 1241
for information on how to change this setting.
server-timeout When the Authentication Server does not respond to a message sent from the
Client, the amount of time before the Dell PowerConnect device retransmits the
message.
Refer to “Specifying a timeout for retransmission of messages to the
authentication server” on page 1242 for information on how to change this
setting.
maxreq The number of times the Dell PowerConnect device retransmits an
EAP-request/identity frame if it does not receive an EAP-response/identity frame
from a Client (default 2 times).
Refer to “Setting the maximum number of EAP frame retransmissions” on
page 1241 for information on how to change this setting.
re-authperiod How often the device automatically re-authenticates Clients when periodic
re-authentication is enabled (default 3,600 seconds).
Refer to “Configuring periodic re-authentication” on page 1239 for information on
how to change this setting.
Protocol Version The version of the 802.1X protocol in use on the device.