Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 107
53-1002266-01
Building an IronStack
5
PowerConnect# show running config
Current configuration:
!
ver 07.2.00a
!
stack unit 1
module 1 FCX-24-port-management-module
priority 255
stack unit 2
module 1 FCX-24-port-management-module
priority 240
stack unit 3
module 1 FCX-24-port-management-module
stack enable
!
NOTE
For field descriptions for the show running config command, refer to “Displaying running
configuration information” on page 143.
10. To see information about your stack, enter the show stack command.
PowerConnect# show stack
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S FCX624 active 00e0.5200.0100 255 local Ready
2 S FCX624 standby 0012.f2eb.afc0 240 remote Ready
3 S FCX624 member 001b.ed5d.a1c0 0 remote Ready
active standby
+---+ +---+ +---+
-2/1| 1 |3/1--2/1| 2 |3/1--2/2| 3 |2/1-
| +---+ +---+ +---+ |
| |
|-------------------------------------|
Current stack management MAC is 00e0.5200.0100
PowerConnect#
NOTE
For field descriptions for the show stack command, refer to “Displaying stack information” on
page 135.
Configuration notes for scenario 2
Consider the following items when building a stack using the automatic setup process:
• If a new unit configuration matches other unit configurations, the Active Controller gives this
unit the lowest sequential ID.
• In a ring topology, the same new unit might assume either ID if either direction produces
sequential IDs. For example, in a four-member stack where IDs 2 and 4 are reserved, a new
unit could assume either I2 or ID 4 because either ID 1,2,3 or 1, 3, 4 is sequential.