Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
232 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Configuring STP related features
8
NOTE
Configuring shared media or non-point-to-point links as point-to-point links could lead to Layer 2
loops.
The topology in Figure 28 is an example of shared media that should not be configured as
point-to-point links. In Figure 28, a port on a bridge communicates or is connected to at least two
ports.
FIGURE 28 Example of shared media
Bridge port states
Ports roles can have one of the following states:
Forwarding – 802.1W is allowing the port to send and receive all packets.
Discarding – 802.1W has blocked data traffic on this port to prevent a loop. The device or
VLAN can reach the root bridge using another port, whose state is forwarding. When a port is
in this state, the port does not transmit or receive data frames, but the port does continue to
receive RST BPDUs. This state corresponds to the listening and blocking states of 802.1D.
Learning – 802.1W is allowing MAC entries to be added to the filtering database but does not
permit forwarding of data frames. The device can learn the MAC addresses of frames that the
port receives during this state and make corresponding entries in the MAC table.
Disabled – The port is not participating in 802.1W. This can occur when the port is
disconnected or 802.1W is administratively disabled on the port.
A port on a non-root bridge with the role of Root port is always in a forwarding state. If another port
on that bridge assumes the Root port role, then the old Root port moves into a discarding state as
it assumes another port role.
A port on a non-root bridge with a Designated role starts in the discarding state. When that port
becomes elected to the Root port role, 802.1W quickly places it into a forwarding state. However, if
the Designated port is an Edge port, then the port starts and stays in a forwarding state and it
cannot be elected as a Root port.
A port with an Alternate or Backup role is always in a discarding state. If the port role changes to
Designated, then the port changes into a forwarding state.
If a port on one bridge has a Designated role and that port is connected to a port on another bridge
that has an Alternate or Backup role, the port with a Designated role cannot be given a Root port
role until two instances of the forward delay timer expires on that port.