Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 325
53-1002266-01
Displaying and modifying system parameter default settings
9
Modifying system parameter default values
Information for the configurable tables appears under the columns that are shown in bold type in
the above examples. To simplify configuration, the command parameter you enter to configure the
table is used for the table name. For example, to increase the capacity of the IP route table, enter
the following commands.
hw-ip-mcast-mll Multicast output interfaces (clients)
hw-ip-next-hop IP next hops and routes, including unicast next hops and multicast route
entries
hw-logical-interface Hardware logical interface pairs (physical port and VLAN pairs)
hw-traffic-conditioner Traffic policies
ip-arp ARP entries
ip-cache IP forwarding cache entries
ip-filter-port IP ACL entries per port
ip-filter-sys IP ACL entries per system
ip-qos-session Layer 4 session table entries
ip-route Learned IP routes
ip-static-arp Static IP ARP entries
ip-static-route Static IP routes
ip-subnet-port IP subnets per port
l3-vlan Layer 3 VLANs
mac MAC entries
mac-filter-port MAC address filter entries per port
mac-filter-sys MAC address filter entries per system
multicast-route Multicast routes
pim-mcache PIM multicast cache entries
rmon-entries RMON control table entries
session-limit Session entries
spanning-tree Spanning tree instances
view SNMP views
virtual-interface Virtual routing interfaces
vlan VLANs
mld-max-group-addr MLD group limit
igmp-snoop-mcache IGMP snooping cache entries
mld-snoop-mcache MLD snooping cache entries
TABLE 58 System parameters in show default values command (Continued)
This system parameter... Defines the maximum number of...