Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
12 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Logging on through the Web Management Interface
1
FIGURE 2 Web Management Interface login dialog
The login username and password you enter depends on whether your device is configured with
AAA authentication for SNMP. If AAA authentication for SNMP is not configured, you can use the
user name “get” and the default read-only password “public” for read-only access. However, for
read-write access, you must enter “set” for the user name, and enter a read-write community string
you have configured on the device for the password. There is no default read-write community
string. You must add one using the CLI.
As an alternative to using the SNMP community strings to log in, you can configure the Dell
PowerConnect device to secure Web management access using local user accounts or Access
Control Lists (ACLs).
Navigating the Web Management Interface
When you log into a device, the System configuration panel is displayed. This panel allows you to
enable or disable major system features. You can return to this panel from any other panel by
selecting the Home link.
The Site Map link gives you a view of all available options on a single screen.
Figure 3 displays the first Web Management Interface panel for Layer 3 Switch features, while
Figure 4 displays the first panel for Layer 2 Switch features. These panels allow you to configure the
features supported by the Layer 3 Switch and Layer 2 Switch software.