Dell FCX624-E Laptop User Manual


  Open as PDF
of 1494
 
862 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Configuring IP parameters – Layer 2 Switches
26
DHCP Log messages
The following DHCP notification messages are sent to the log file.
2d01h48m21s:I: DHCPC: existing ip address found, no further action needed by DHCPC
2d01h48m21s:I: DHCPC: Starting DHCP Client service
2d01h48m21s:I: DHCPC: Stopped DHCP Client service
2d01h48m21s:I: DHCPC: FCX624P Switch running-configuration changed
2d01h48m21s:I: DHCPC: sending TFTP request for bootfile name FCX-switch.cfg
2d01h48m21s:I: DHCPC: TFTP unable to download running-configuration
2d01h48m21s:I: DHCPC: Found static IP Address 1.1.1.1 subnet mask 255.255.255.0 on
port 0/1/5
2d01h48m21s:I: DHCPC: Client service found no DHCP server(s) on 3 possible subnet
2d01h48m21s:I: DHCPC: changing 0/1/3 protocol from stopped to running
Configuring IP parameters – Layer 2 Switches
The following sections describe how to configure IP parameters on a Layer 2 Switch.
NOTE
This section describes how to configure IP parameters for Layer 2 Switches. For IP configuration
information for Layer 3 Switches, refer to “Configuring IP parameters – Layer 3 Switches” on
page 799.
PowerConnect(config)# show run
Current configuration:
!
ver 7.2.00aT7f1
!
module 1 FCX-24-port-management-module
module 2 FCX-cx4-2-port-16g-module
module 3 FCX-xfp-1-port-16g-module
!
vlan 1 name DEFAULT-VLAN by port
!
ip dns domain-name test.com
ip dns server-address 10.44.3.111
interface ethernet 0/1/2
ip address 10.44.3.233 255.255.255.0 dynamic
ip dhcp-client lease 691109
!
interface ethernet 0/1/15
ip address 1.0.0.1 255.0.0.0
ip helper-address 1 10.44.3.111
!
end