Filter
Top Products
930 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
OSPF graceful restart
29
You also can change the amount of memory allocated to various types of LSA entries. However,
these changes require a system reset or reboot.
Dynamic OSPF memory
PowerConnect devices dynamically allocate memory for Link State Advertisements (LSAs) and
other OSPF data structures. This eliminates overflow conditions and does not require a reload to
change OSPF memory allocation. So long as the Layer 3 Switch has free (unallocated) dynamic
memory, OSPF can use the memory.
To display the current allocations of dynamic memory, use the show memory command.
OSPF graceful restart
OSPF graceful restart is a high-availability routing feature that minimizes disruption in traffic
forwarding, diminishes route flapping, and provides continuous service during a system restart,
including restart events that occur during a switchover, failover, or hitless OS upgrade. During such
events, routes remain available between devices.
When OSPF graceful restart is enabled, a restarting router sends special LSAs, called grace LSAs,
to its neighbors either before a planned OSPF restart or immediately after an unplanned restart.
The grace LSAs specify a grace period for neighbors of the restarting router to continue using the
existing routes to and through the router after a restart. When the restarting router comes back up,
it continues to use its existing OSPF routes as if nothing happened. In the background, the router
relearns its neighbors prior to the restart, recalculates its OSPF routes, and replaces existing routes
with new routes as necessary. Once the grace period has passed, adjacent routers resume normal
operation.
OSPF graceful restart is enabled globally by default. In this configuration, all OSPF neighbors are
subject to the graceful restart capability. Neighbor routers must support the helper mode of OSPF
graceful restart, which is enabled by default on all PowerConnect Layer 3 switches.
NOTE
If a PowerConnect device is configured for OSPF graceful restart and is intended to be used in
switchover or hitless upgrade, the OSPF dead-interval should be changed to 60 seconds on OSPF
interfaces to ensure that the graceful restart process succeeds without a timeout. Instructions for
changing the OSPF dead-interval are provided in “Modifying interface defaults” on page 937.
The Dell implementation of OSPF graceful restart supports RFC 3623: Graceful OSPF Restart.
For details on how to configure OSPF graceful restart, refer to “Configuring OSPF graceful restart”
on page 963.
Configuring OSPF
Perform the following steps to begin using OSPF on the router.
1. Enable OSPF on the router.
2. Assign the areas to which the router will be attached.
3. Assign individual interfaces to the OSPF areas.