Filter
Top Products
978 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying OSPF information
29
PowerConnect#show ip ospf border-routers
Syntax: show ip ospf border-routers [<ip-addr>]
The <ip-addr> parameter displays the ABR and ASBR entries for the specified IP address.
Displaying OSPF trap status
All traps are enabled by default when you enable OSPF. To disable or re-enable an OSPF trap, refer
to “Modifying OSPF traps generated” on page 961.
To display the state of each OSPF trap, enter the following command at any CLI level.
Syntax: show ip ospf trap
Displaying OSPF graceful restart information
To display OSPF graceful restart information for OSPF neighbors, use the show ip ospf neighbors
command.
PowerConnect#show ip ospf neighbors
Port Address Pri State Neigh Address Neigh ID Ev Opt Cnt
2/7 50.50.50.10 0 FULL/OTHER 50.50.50.1 10.10.10.30 21 66 0
< in graceful restart state, helping 1, timer 60 sec >
Syntax: show ip ospf neighbor
Use the following command to display Type 9 grace LSAs on a PowerConnect Layer 3 switch.
PowerConnect#show ip ospf database grace-link-state
Graceful Link States
Area Interface Adv Rtr Age Seq(Hex) Prd Rsn Nbr Intf IP
0 eth 1/2 2.2.2.2 7 80000001 60 SW 6.1.1.2
Syntax: show ip ospf database grace-link-state
PowerConnect#show ip ospf trap
Interface State Change Trap: Enabled
Virtual Interface State Change Trap: Enabled
Neighbor State Change Trap: Enabled
Virtual Neighbor State Change Trap: Enabled
Interface Configuration Error Trap: Enabled
Virtual Interface Configuration Error Trap: Enabled
Interface Authentication Failure Trap: Enabled
Virtual Interface Authentication Failure Trap: Enabled
Interface Receive Bad Packet Trap: Enabled
Virtual Interface Receive Bad Packet Trap: Enabled
Interface Retransmit Packet Trap: Enabled
Virtual Interface Retransmit Packet Trap: Enabled
Originate LSA Trap: Enabled
Originate MaxAge LSA Trap: Enabled
Link State Database Overflow Trap: Enabled
Link State Database Approaching Overflow Trap: Enabled