Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
1050 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Filtering
30
These commands configure a route map that matches on routes whose destination network is
specified in ACL 1, and sets the next hop in the routes to the neighbor address (inbound filtering) or
the local IP address of the BGP4 session (outbound filtering).
Syntax: set ip next-hop peer-address
The value that the software substitutes for peer-address depends on whether the route map is
used for inbound filtering or outbound filtering:
When you use the set ip next-hop peer-address command in an inbound route map filter,
peer-address substitutes for the neighbor IP address.
When you use the set ip next-hop peer-address command in an outbound route map filter,
peer-address substitutes for the local IP address of the BGP4 session.
NOTE
You can use this command for a peer group configuration.
Deleting a community from a BGP4 route
To delete a community from a BGP4 route community attributes field, enter commands such as the
following.
PowerConnect(config)#ip community-list standard std_3 permit 12:99 12:86
PowerConnect(config)#route-map bgp6 permit 1
PowerConnect(config-routemap bgp6)#match ip address 1
PowerConnect(config-routemap bgp6)#set comm-list std_3 delete
The first command configures a community ACL containing community numbers 12:99 and 12:86.
The remaining commands configure a route map that matches on routes whose destination
network is specified in ACL 1, and deletes communities 12:99 and 12:86 from those routes. The
route does not need to contain all the specified communities in order for them to be deleted. For
example, if a route contains communities 12:86, 33:44, and 66:77, community 12:86 is deleted.
Syntax: set comm-list <ACL> delete
The <ACL> parameter specifies the name of a community list ACL.
Using a table map to set the rag value
Route maps that contain set statements change values in routes when the routes are accepted by
the route map. For inbound route maps (route maps that filter routes received from neighbors), this
means that the routes are changed before they enter the BGP4 route table.
For tag values, if you do not want the value to change until a route enters the IP route table, you can
use a table map to change the value. A table map is a route map that you have associated with the
IP routing table. The Layer 3 Switch applies the set statements for tag values in the table map to
routes before adding them to the route table.
To configure a table map, you configure the route map, then identify it as a table map. The table
map does not require separate configuration. You create it simply by calling an existing route map a
table map. You can have one table map.
NOTE
Use table maps only for setting the tag value. Do not use table maps to set other attributes. To set
other route attributes, use route maps or filters.