Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
1122 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying VRRP and VRRPE information
31
mode owner
priority 99
current priority 99
hello-interval 1 sec
ip-address 192.53.5.1
backup routers 192.53.5.2
This example shows that even though this Layer 3 Switch is the Owner of the VRID (“mode owner”),
the Layer 3 Switch priority for the VRID is only 99 and the state is now “backup” instead of “active”.
In addition, the administrative status is “enabled”.
To change the Master priority back to the default Owner priority 255, enter “no” followed by the
command you entered to change the priority. For example, to change the priority of a VRRP Owner
back to 255 from 99, enter the following command.
PowerConnect(config-if-1/6-vrid-1)#no owner priority 99
You cannot set the priority to 255 using the owner priority command.
Displaying VRRP and VRRPE information
You can display the following information for VRRP or VRRPE:
Summary configuration and status information
Detailed configuration and status information
VRRP and VRRPE Statistics
CPU utilization statistics
Displaying summary information
To display summary information for a Layer 3 Switch, enter the following command at any level of
the CLI.
The above example is for VRRP. Here is an example for VRRPE.
Syntax: show ip vrrp brief | ethernet [<slotnum>/]<portnum> | ve <num> | stat
Syntax: show ip vrrp-extended brief | ethernet [<slotnum>/]<portnum> | ve <num> | stat
The brief parameter displays the summary information. If you do not use this parameter, detailed
information is displayed instead. Refer to “Displaying detailed information” on page 1123.
The <slotnum> parameter is required on chassis devices if you specify a port number.
PowerConnect#show ip vrrp brief
Total number of VRRP routers defined: 1
Interface VRID CurPri P State Master addr Backup addr VIP
1/6 1 255 P Init 192.53.5.1 192.53.5.3 192.53.5.1
PowerConnect#show ip vrrp-extended brief
Total number of VRRP-Extended routers defined: 1
Interface VRID CurPri P State Master addr Backup addr VIP
1/6 1 255 P Init 192.53.5.2 192.53.5.3 192.53.5.254