Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 1127
53-1002266-01
Displaying VRRP and VRRPE information
31
Displaying detailed information for an individual VRID
You can display information about the settings configured for a specified VRRP Virtual Router ID
(VRID). For example, to display information about VRID 1.
Syntax: show ip vrrp vrid <num> [ethernet <num> | ve <num>]
The <num> parameter specifies the VRID.
The ethernet <num> | ve <num> specifies an interface on which the VRID is configured. If you
specify an interface, VRID information is displayed for that interface only. Otherwise, information is
displayed for all the interfaces on which the specified VRID is configured.
This display shows the following information.
master router <ip-addr> expires
in <time>
The IP address of the Master and the amount of time until the Master dead
interval expires. If the Backup does not receive a Hello message from the
Master by the time the interval expires, either the IP address listed for the
Master will change to the IP address of the new Master, or this Layer 3 Switch
itself will become the Master.
NOTE: This field applies only when this Layer 3 Switch is a Backup.
track port The interfaces that the VRID interface is tracking. If the link for a tracked
interface goes down, the VRRP or VRRPE priority of the VRID interface is
changed, causing the devices to renegotiate for Master.
NOTE: This field is displayed only if track interfaces are configured for this
VRID.
TABLE 197 Output from the show ip vrrp vrid command
This field... Displays...
VRID The specified VRID.
Interface The interface on which VRRP is configured.
TABLE 196 CLI display of VRRP or VRRPE detailed information (Continued)
This field... Displays...
PowerConnect#show ip vrrp vrid 1
VRID 1
Interface ethernet 3/11
state initialize
administrative-status disabled
mode non-owner(backup)incomplete
priority 12
current priority 12
track-priority 22
hello-interval 1 sec
dead-interval 0 sec
current dead-interval 3.900 sec
preempt-mode true
advertise backup: disabled