Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
1128 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying VRRP and VRRPE information
31
Displaying statistics
To display statistics on most Dell devices, enter a command such as the following at any level of the
CLI.
The same statistics are listed for VRRP and VRRPE.
Syntax: show ip vrrp brief | ethernet [<slotnum>/]<portnum> | ve <num> | statistic
State This Layer 3 Switch VRRP state for the VRID. The state can be one of the
following:
Init – The VRID is not enabled (activated). If the state remains Init after
you activate the VRID, make sure that the VRID is also configured on the
other routers and that the routers can communicate with each other.
NOTE: If the state is Init and the mode is incomplete, make sure you have
specified the IP address for the VRID:
Backup – This Layer 3 Switch is a Backup for the VRID.
Master – This Layer 3 Switch is the Master for the VRID.
priority The configured VRRP priority of this Layer 3 Switch for the VRID.
current priority The current VRRP priority of this Layer 3 Switch for the VRID.
track-priority The new VRRP priority that the router receives for this VRID if the interface goes
down
hello-interval How often the Master router sends Hello messages to the Backups.
dead-interval The amount of time a Backup waits for a Hello message from the Master before
determining that the Master is dead.
current dead-interval The current Dead interval. The software automatically adds one-half second to
the Dead interval value you enter.
preempt-mode Whether the backup preempt mode is enabled. If the backup preempt mode is
enabled, this field contains “true”. If the mode is disabled, this field contains
“false”.
advertise backup Whether Backup routers send Hello messages to the Master.
TABLE 197 Output from the show ip vrrp vrid command (Continued)
This field... Displays...
PowerConnect#show ip vrrp statistic
Interface ethernet 1/5
rxed vrrp header error count = 0
rxed vrrp auth error count = 0
rxed vrrp auth passwd mismatch error count = 0
rxed vrrp vrid not found error count = 0
VRID 1
rxed arp packet drop count = 0
rxed ip packet drop count = 0
rxed vrrp port mismatch count = 0
rxed vrrp ip address mismatch count = 0
rxed vrrp hello interval mismatch count = 0
rxed vrrp priority zero from master count = 0
rxed vrrp higher priority count = 0
transitioned to master state count = 1
transitioned to backup state count = 1