Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 1255
53-1002266-01
Displaying 802.1X information
34
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Displaying 802.1X multiple-host authentication information
You can display the following information about 802.1X multiple-host authentication:
Information about the 802.1X multiple-host configuration
The dot1x-mac-sessions on each port
The number of users connected on each port in a 802.1X multiple-host configuration
Displaying 802.1X multiple-host configuration information
The output of the show dot1x and show dot1x config commands displays information related to
802.1X multiple-host authentication.
The following is an example of the output of the show dot1x command. The information related to
multiple-host authentication is highlighted in bold.
Syntax: show dot1x
Table 215 describes the bold fields in the display.
TABLE 215 Output from the show dot1x command for multiple host authentication
This field... Displays...
Authentication-fail-action The configured authentication-failure action. This can be Restricted
VLAN or Block Traffic.
Authentication Failure VLAN If the authentication-failure action is Restricted VLAN, the ID of the VLAN
to which unsuccessfully authenticated Client ports are assigned.
Mac Session Aging Whether aging for dot1x-mac-sessions has been enabled or disabled for
permitted or denied dot1x-mac-sessions.
Mac Session max-age The configured software aging time for dot1x-mac-sessions.
Flow based multi-user policy The dynamically assigned IP ACLs and MAC address filters used in the
802.1X multiple-host configuration.
PowerConnect#show dot1x
Number of Ports enabled : 2
Re-Authentication : Enabled
Authentication-fail-action : Restricted VLAN
Authentication Failure VLAN : 111
Mac Session Aging : Disabled for permitted MAC sessions
Mac Session max-age : 60 seconds
Protocol Version : 1
quiet-period : 5 Seconds
tx-period : 30 Seconds
supptimeout : 30 Seconds
servertimeout : 30 Seconds
maxreq : 2
re-authperiod : 3600 Seconds
security-hold-time : 60 Seconds
re-authentication : Enable
Flow based multi-user policy : Disable