Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 1317
53-1002266-01
Configuring the web authentication mode
37
The next dynamically-created passcode will be 10 digits in length, for example, 0123456789.
Syntax: auth-mode passcode length <value>
For <value>, enter a number from 4 to 16.
Configuring the passcode refresh method
Passcode authentication supports two passcode refresh methods:
• Duration of time – By default, dynamically-created passcodes are refreshed every 1440
minutes (24 hours). When refreshed, a new passcode is generated and the old passcode
expires. You can increase or decrease the duration of time after which passcodes are
refreshed, or you can configure the device to refresh passcodes at a certain time of day
instead of after a duration of time.
• Time of day – When initially enabled, the time of day method will cause passcodes to be
refreshed at 0:00 (12:00 midnight). If desired, you can change this time of day, and you can
add up to 24 refresh periods in a 24-hour period.
When a passcode is refreshed, the old passcode will no longer work, unless a grace period is
configured (refer to “Configuring a Grace Period for an expired passcode” on page 1318).
If a user changes the passcode refresh value, the configuration is immediately applied to the
current passcode. For example, if the passcode duration is 100 minutes and the passcode was
last generated 60 minutes prior, a new passcode will be generated in 40 minutes. However, if the
passcode duration is changed from 100 to 75 minutes, and the passcode was last generated 60
minutes prior, a new passcode will be generated in 15 minutes. Similarly, if the passcode duration
is changed from 100 to 50 minutes, and the passcode was last generated 60 minutes prior, the
passcode will immediately expire and a new passcode will be generated. The same principles
apply to the time of day passcode refresh method.
If you configure both duration of time and time of day passcode refresh values, they are saved to
the configuration file. You can switch back and forth between the passcode refresh methods, but
only one method can be enabled at a time.
NOTE
Passcodes are not stateful, meaning a software reset or reload will cause the system to erase the
passcode. When the PowerConnect switch comes back up, a new passcode will be generated.
Changing the passcode refresh duration
To change the duration of time after which passcodes are refreshed, enter commands such as the
following.
PowerConnect(config-vlan-10-webauth)#auth-mode passcode refresh-type duration
4320
The passcode will be refreshed after 4320 minutes (72 hours).
Syntax: auth-mode passcode refresh-type duration <value>
For <value>, enter a number from 5 to 9999 minutes. The default is 1440 minutes (24 hours).
Refreshing passcodes at a certain time of the day
You can configure the PowerConnect switch to refresh passcodes at a certain time of day, up to 24
times each day, instead of after a duration of time. When this feature is enabled, by default
passcodes will be refreshed at 00:00 (12 midnight).