Filter
Top Products
1396 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Syslog messages
41
Informational Bridge root changed, vlan <vlan-id>, new
root ID <string>, root interface <portnum>
A Spanning Tree Protocol (STP) topology
change has occurred.
The <vlan-id> is the ID of the VLAN in which
the STP topology change occurred.
The <root-id> is the STP bridge root ID.
The <portnum> is the number of the port
connected to the new root bridge.
Informational Bridge topology change, vlan <vlan-id>,
interface <portnum>, changed state to
<stp-state>
A Spanning Tree Protocol (STP) topology
change has occurred on a port.
The <vlan-id> is the ID of the VLAN in which
the STP topology change occurred.
The <portnum> is the port number.
The <stp-state> is the new STP state and
can be one of the following:
• disabled
• blocking
• listening
• learning
• forwarding
• unknown
Informational Cold start The device has been powered on.
Informational DHCP : snooping on untrusted port
<portnum>, type <number>, drop
The device has indicated that the DHCP
client receives DHCP server reply packets
on untrusted ports, and packets are
dropped.
Informational DOT1X : port <portnum> - mac <mac
address> Cannot apply an ACL or MAC filter
on a port member of a VE (virtual interface)
The RADIUS server returned an IP ACL or
MAC address filter, but the port is a
member of a virtual interface (VE).
Informational DOT1X : port <portnum> - mac <mac
address> cannot remove inbound ACL
An error occurred while removing the
inbound ACL.
Informational DOT1X : port <portnum> - mac <mac
address> Downloading a MAC filter, but MAC
filter have no effect on router port
The RADIUS server returned an MAC
address filter, but the <portnum> is a router
port (it has one or more IP addresses).
Informational DOT1X : port <portnum> - mac <mac
address> Downloading an IP ACL, but IP ACL
have no effect on a switch port
The RADIUS server returned an IP ACL, but
the <portnum> is a switch port (no IP
address).
Informational DOT1X : port <portnum> - mac <mac
address> Error - could not add all MAC filters
The Dell PowerConnect device was unable
to implement the MAC address filters
returned by the RADIUS server.
Informational DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID
doesn't exist
The MAC address filter ID returned by the
RADIUS server does not exist in the Dell
PowerConnect configuration.
Informational DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID is user
defined and cannot be used
The port was assigned a MAC address filter
ID that had been dynamically created by
another user.
TABLE 239 Syslog messages (Continued)
Message level Message Explanation