Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 249
53-1002266-01
Configuring STP related features
8
When Port2/Switch 2 receives the RST BPDUs, 802.1W algorithm determines that the RST BPDUs
the port received are better than those received on Port3/Switch 3; therefore, Port2/Switch 2 is
given the role of a Root port. All the ports on Switch 2 are informed that a new Root port has been
assigned which then signals all the ports to synchronize their roles and states. Port3/Switch 2,
which was the previous Root port, enters a discarding state and negotiates with other ports on the
bridge to establish its new role and state, until it finally assumes the role of a Designated port.
Next, the following happens:
Port3/Switch 2, the Designated port, sends an RST BPDU, with a proposal flag to Port3/Switch
3.
Port2/Switch 2 also sends an RST BPDU with an agreed flag to Port2/Switch 1 and then
places itself into a forwarding state.
When Port2/Switch 1 receives the RST BPDU with an agreed flag sent by Port2/Switch 2, it puts
that port into a forwarding state. The topology is now fully converged.
When Port3/Switch 3 receives the RST BPDU that Port3/Switch 2 sent, 802.1W algorithm
determines that these RST BPDUs are superior to those that Port3/Switch 3 can transmit.
Therefore, Port3/Switch 3 is given a new role, that of an Alternate port. Port3/Switch 3 immediately
enters a discarding state.
Now Port3/Switch 2 does not go into a forwarding state instantly like the Root port. It waits until the
forward delay timer expires twice on that port while it is still in a Designated role, before it can
proceed to the forwarding state. The wait, however, does not cause a denial of service, since the
essential connectivity in the topology has already been established.
When fully restored, the topology is the same as that shown on Figure 40.