Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 423
53-1002266-01
Displaying and determining the status of aggregate links
12
NOTE
Ports that are configured as part of an aggregate link must also have the same key. For more
information about assigning keys, refer to the section “Link aggregation parameters” on page 416.
The show link-aggregate command shows the following information.
TABLE 75 CLI display of link aggregation information
This field... Displays...
System ID Lists the base MAC address of the device. This is also the MAC address of port 1 (or 1/1).
Port Lists the port number.
Sys P Lists the system priority configured for this port.
Port P Lists the port link aggregation priority.
Key Lists the link aggregation key.
This column displays “singleton” if the port is configured with a Single Instance of LACP. (Refer to
“Configuring single link LACP” on page 425 for more details.
Act Indicates the link aggregation mode, which can be one of the following:
No – The mode is passive or link aggregation is disabled (off) on the port.
If link aggregation is enabled (and the mode is passive), the port can send and receive
LACPDU messages to participate in negotiation of an aggregate link initiated by another
port, but cannot search for a link aggregation port or initiate negotiation of an aggregate
link.
Yes – The mode is active. The port can send and receive LACPDU messages.
Tio Indicates the timeout value of the port. The timeout value can be one of the following:
L – Long. The trunk group has already been formed and the port is therefore using a longer
message timeout for the LACPDU messages exchanged with the remote port. Typically,
these messages are used as confirmation of the health of the aggregate link.
S – Short. The port has just started the LACPDU message exchange process with the port
at the other end of the link. The S timeout value also can mean that the link aggregation
information received from the remote port has expired and the ports are starting a new
information exchange.
Agg Indicates the link aggregation state of the port. The state can be one of the following:
Agg – Link aggregation is enabled on the port.
No – Link aggregation is disabled on the port.
Syn Indicates the synchronization state of the port. The state can be one of the following:
No – The port is out of sync with the remote port. The port does not understand the status
of the LACPDU process and is not prepared to enter a trunk link.
Syn – The port is in sync with the remote port. The port understands the status of the
LACPDU message exchange process, and therefore knows the trunk group to which it
belongs, the link aggregation state of the remote port, and so on.
Col Indicates the collection state of the port, which determines whether the port is ready to send
traffic over the trunk link.
Col – The port is ready to send traffic over the trunk link.
No – The port is not ready to send traffic over the trunk link.
Dis Indicates the distribution state of the port, which determines whether the port is ready to receive
traffic over the trunk link.
Dis – The port is ready to receive traffic over the trunk link.
No – The port is not ready to receive traffic over the trunk link.