Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
664 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying IGMP snooping information
22
Syntax: show ip multicast group [<group-address> [detail] [tracking]]
If you want a report for a specific multicast group, enter that group's address for <group-address>.
Enter detail to display the source list of a specific VLAN.
Enter tracking for information on interfaces that have tracking enabled.
The following table describes the information displayed by the show ip multicast group command.
Displaying IGMP snooping mcache information
The IGMP snooping mcache contains multicast forwarding information for VLANs. To display
information in the multicast forwarding mcache, enter the following command.
Field Description
group The address of the group (destination address in this case, 224.1.1.1)
p-port The physical port on which the group membership was received.
ST Yes indicates that the IGMP group was configured as a static group; No means the address
was learned from reports.
QR Yes means the port is a querier port; No means it is not. A port becomes a non-querier port
when it receives a query from a source with a lower source IP address than the device.
life The number of seconds the group can remain in EXCLUDE mode. An EXCLUDE mode changes
to INCLUDE mode if it does not receive an "IS_EX" or "TO_EX" message during a certain period
of time. The default is 140 seconds. There is no life displayed in INCLUDE mode.
mode Indicates current mode of the interface: INCLUDE or EXCLUDE. If the interface is in INCLUDE
mode, it admits traffic only from the source list. If an interface is in EXCLUDE mode, it denies
traffic from the source list and accepts the rest.
source Identifies the source list that will be included or excluded on the interface.
For example, if an IGMPv2 group is in EXCLUDE mode with a source of 0, the group excludes
traffic from the 0 (zero) source list, which actually means that all traffic sources are included.
PowerConnect# show ip multicast group 224.1.1.1 tracking
Display group 224.1.1.1 in all interfaces with tracking enabled.
p-:physical, ST:static, QR:querier, EX:exclude, IN:include, Y:yes, N:no
VL70 : 1 groups, 1 group-port, tracking_enabled
group p-port ST QR life mode source
*** Note: has 1 static groups to the entire vlan, not displayed here
1 224.1.1.1 0/1/33 no yes 100 EX 0
receive reports from 1 clients: (age)
(2.2.100.2 60)
PowerConnect# show ip multicast mcache
Example: (S G) cnt=: cnt: SW proc. count
OIF: 0/1/22 TR(0/1/32,0/1/33), TR is trunk, 0/1/32 primary, 0/1/33 output
vlan 1, 1 caches. use 1 VIDX
1 (1.2.10.102 225.1.1.1) cnt=46
OIF: 0/1/4
age=0m up-time=45m vidx=4130 (ref-cnt=1)
vlan 70, 1 caches. use 1 VIDX
1 (* 226.1.2.3) cnt=69
OIF: 0/1/14
age=0m up-time=59m vidx=4129 (ref-cnt=1)