Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
752 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
PIM Sparse
25
Syntax: show ip pim group
This display shows the following information.
Displaying BSR information
To display BSR information, enter the following command at any CLI level.
This example show information displayed on a Layer 3 Switch that has been elected as the BSR.
The following example shows information displayed on a Layer 3 Switch that is not the BSR. Notice
that some fields shown in the example above do not appear in the example below.
PowerConnect#show ip pim bsr
PIMv2 Bootstrap information
local BSR address = 207.95.7.1
local BSR priority = 5
Syntax: show ip pim bsr
This display shows the following information.
TABLE 128 Output of show ip pim group
This field... Displays...
Total number of Groups Lists the total number of IP multicast groups the Layer 3 Switch is forwarding.
NOTE: This list can include groups that are not PIM Sparse groups. If interfaces on
the Layer 3 Switch are configured for regular PIM (dense mode) or DVMRP,
these groups are listed too.
Index The index number of the table entry in the display.
Group The multicast group address
Ports The Layer 3 Switch ports connected to the receivers of the groups.
PowerConnect#show ip pim group
Total number of Groups: 2
Index 1 Group 239.255.162.1 Ports e3/11
PowerConnect#show ip pim bsr
PIMv2 Bootstrap information
This system is the elected Bootstrap Router (BSR)
BSR address: 207.95.7.1
Uptime: 00:33:52, BSR priority: 5, Hash mask length: 32
Next bootstrap message in 00:00:20
Next Candidate-RP-advertisement in 00:00:10
RP: 207.95.7.1
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60