Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 903
53-1002266-01
Configuring MLD snooping
27
Displaying status of MLD snooping traffic
To display status information for MLD snooping traffic, enter the following command.
Syntax: show ipv6 mld-snooping traffic
The following table describes the information displayed by the show ipv6 mld-snooping traffic
command.
get-fail Displays the number of resource failures.
NOTE: It is important to pay close attention to this field.
limit The upper limit of this expandable field. The MLD group limit is configured using the system-max
mld-max-group-addr command. The snoop mcache entry limit is configured using the
system-max mld-snoop-mcache command.
get-mem The number of memory allocation. This number should continue to increase.
size The size of a unit (in bytes).
init The initial allocated amount of memory.
NOTE: This number can be increased. More memory can be allocated if necessary.
Available vidx The output interface (OIF) port mask used by mcache. The entire device has a maximum of
4096 vidx. Different mcaches with the same OIF share the same vidx. If vidx is not available, the
stream cannot be hardware-switched.
This field Displays
QQuery
Qry General Query
QryV1 Number of general MLDv1 queries received or sent.
QryV2 Number of general MLDv2 snooping queries received or sent.
G-Qry Number of group specific queries received or sent.
GSQry Number of group source specific queries received or sent.
MBR The membership report.
MbrV1 The MLDv1 membership report.
MbrV2 The MLDv2 membership report.
IsIN Number of source addresses that were included in the traffic.
This field... Displays...
PowerConnect#show ipv6 mld-snooping traffic
MLD snooping: Total Recv: 32208, Xmit: 166
Q: query, Qry: general Q, G-Qry: group Q, GSQry: group-source Q, Mbr: member
Recv QryV1 QryV2 G-Qry GSQry MbrV1 MbrV2 Leave
VL1 0 0 0 0 31744 208 256
VL70 0 0 0 0 0 0 0
Recv IsIN IsEX ToIN ToEX ALLOW BLOCK Pkt-Err
VL1 1473 31784 0 1 1 7 0
VL70 0 0 0 0 0 0 0
Send QryV1 QryV2 G-Qry GSQry MbrV1 MbrV2
VL1 0 0 166 0 0 0
VL70 0 0 0 0 0 0