Dell FCX624-I Laptop User Manual


  Open as PDF
of 1494
 
922 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Overview of OSPF
29
This chapter describes how to configure OSPF Version 2 on Layer 3 Switches using the CLI. OSPF
Version 2 is supported on devices running IPv4.
NOTE
The terms Layer 3 Switch and router are used interchangeably in this chapter and mean the same
thing.
Overview of OSPF
OSPF is a link-state routing protocol. The protocol uses link-state advertisements (LSAs) to update
neighboring routers regarding its interfaces and information on those interfaces. The router floods
these LSAs to all neighboring routers to update them regarding the interfaces. Each router
maintains an identical database that describes its area topology to help a router determine the
shortest path between it and any neighboring router.
Layer 3 Switches support the following types of LSAs, which are described in RFC 1583:
Router link
Network link
Summary link
Autonomous system (AS) summary link
AS external link
Not-So-Stubby Area (NSSA) external link
Grace LSAs
OSPF is built upon a hierarchy of network components. The highest level of the hierarchy is the
Autonomous System (AS). An autonomous system is defined as a number of networks, all of which
share the same routing and administration characteristics.
An AS can be divided into multiple areas as shown in Figure 138 on page 923. Each area
represents a collection of contiguous networks and hosts. Areas limit the area to which link-state
advertisements are broadcast, thereby limiting the amount of flooding that occurs within the
network. An area is represented in OSPF by either an IP address or a number.
You can further limit the broadcast area of flooding by defining an area range. The area range
allows you to assign an aggregate value to a range of IP addresses. This aggregate value becomes
the address that is advertised instead all of the individual addresses it represents being
advertised. You can assign up to 32 ranges in an OSPF area.
An OSPF router can be a member of multiple areas. Routers with membership in multiple areas
are known as Area Border Routers (ABRs). Each ABR maintains a separate topological database
for each area the router is in. Each topological database contains all of the LSA databases for each
router within a given area. The routers within the same area have identical topological databases.
The ABR is responsible for forwarding routing information or changes between its border areas.
Syslog messages Yes
Clearing OSPF information Yes
TABLE 174 Supported OSPF V2 features (Continued)
Feature PowerConnect B-Series FCX