Filter
Top Products
966 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying OSPF information
29
Syntax: clear ospf redistribution
This command clears all routes in the OSPF routing table that are redistributed from other
protocols, including direct connected, static, RIP, and BGP. To import redistributed routes from
other protocols, use the redistribution command at the OSPF configuration level.
Clearing information for OSPF areas
To clear information on the Dell PowerConnect device about all OSPF areas, enter the following
command.
PowerConnect#clear ip ospf
This command clears all OSPF areas, all OSPF neighbors, and the entire OSPF routing table. After
this information has been cleared, adjacencies with all neighbors are re-established, and all OSPF
routes are re-learned.
To clear information on the Dell PowerConnect device about OSPF area 1, enter the following
command.
PowerConnect#clear ip ospf area 1
This command clears information about the specified area ID. Information about other OSPF areas
is not affected. The command clears information about all OSPF neighbors belonging to the
specified area, as well as all routes imported into the specified area. Adjacencies with neighbors
belonging to the area are re-established, and routes imported into the area are re-learned.
Syntax: clear ip ospf [area <area-id>]
The <area-id> can be specified in decimal format or in IP address format.
Displaying OSPF information
You can use CLI commands and Web management options to display the following OSPF
information:
• Trap, area, and interface information – refer to “Displaying general OSPF configuration
information” on page 967.
• CPU utilization statistics – refer to “Displaying CPU utilization statistics” on page 968.
• Area information – refer to “Displaying OSPF area information” on page 969.
• Neighbor information – refer to “Displaying OSPF neighbor information” on page 969.
• Interface information – refer to “Displaying OSPF interface information” on page 971.
• Route information – refer to “Displaying OSPF route information” on page 973.
• External link state information – refer to “Displaying OSPF external link state information” on
page 975.
• Link state information – refer to “Displaying OSPF link state information” on page 976.
• Virtual Neighbor information – refer to “Displaying OSPF virtual neighbor information” on
page 977.
• Virtual Link information – refer to “Displaying OSPF virtual link information” on page 977.
• ABR and ASBR information – refer to “Displaying OSPF ABR and ASBR information” on
page 977.