Dell FCX624-S Laptop User Manual


  Open as PDF
of 1494
 
972 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying OSPF information
29
Syntax: show ip ospf interface [<ip-addr>]
The <ip-addr> parameter displays the OSPF interface information for the specified IP address.
The following table defines the highlighted fields shown in the above example output of the show ip
ospf interface command.
TABLE 177 Output of the show ip ospf interface command
Field Definition
IP Address The IP address of the interface.
OSPF state ptr2ptr (point to point)
Pri The link ID as defined in the router-LSA. This value can be one of the
following:
1 = point-to-point link
3 = point-to-point link with an assigned subnet
Cost The configured output cost for the interface.
Options OSPF Options (Bit7 - Bit0):
unused:1
opaque:1
summary:1
dont_propagate:1
nssa:1
multicast:1
externals:1
tos:1
Type The area type, which can be one of the following:
Broadcast = 0x01
NBMA = 0x02
Point to Point = 0x03
Virtual Link = 0x04
Point to Multipoint = 0x05
PowerConnect#show ip ospf interface 192.168.1.1
Ethernet 2/1,OSPF enabled
IP Address 192.168.1.1, Area 0
OSPF state ptr2ptr, Pri 1, Cost 1, Options 2, Type pt-2-pt Events 1
Timers(sec): Transit 1, Retrans 5, Hello 10, Dead 40
DR: Router ID 0.0.0.0 Interface Address 0.0.0.0
BDR: Router ID 0.0.0.0 Interface Address 0.0.0.0
Neighbor Count = 0, Adjacent Neighbor Count= 1
Neighbor: 2.2.2.2
Authentication-Key:None
MD5 Authentication: Key None, Key-Id None, Auth-change-wait-time 300