Dell FCX624-S Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 1049
53-1002266-01
Filtering
30
The metric-type type-1 | type-2 parameter changes the metric type of a route redistributed into
OSPF.
The metric-type internal parameter sets the route's MED to the same value as the IGP metric of the
BGP4 next-hop route. The parameter does this when advertising a BGP4 route to an EBGP
neighbor.
The next-hop <ip-addr> parameter sets the IP address of the route next hop router.
The nlri multicast | unicast | multicast unicast parameter redistributes routes into the multicast
Routing Information Base (RIB) instead of the unicast RIB.
NOTE
Setting the NLRI type to multicast applies only when you are using the route map to redistribute
directly-connected routes. Otherwise, the set option is ignored.
The origin igp | incomplete parameter sets the route origin to IGP or INCOMPLETE.
The tag <tag-value> parameter sets the route tag. You can specify a tag value from 0 through
4294967295.
NOTE
This parameter applies only to routes redistributed into OSPF.
NOTE
You also can set the tag value using a table map. The table map changes the value only when the
Layer 3 Switch places the route in the IP route table instead of changing the value in the BGP route
table. Refer to “Using a table map to set the rag value” on page 1050.
The weight <num> parameter sets the weight for the route. You can specify a weight value from
0 through 4294967295.
Setting a BP4 route MED to the same value as the IGP metric of the next-hop route
To set a route's MED to the same value as the IGP metric of the BGP4 next-hop route, when
advertising the route to a neighbor, enter commands such as the following.
PowerConnect(config)#access-list 1 permit 192.168.9.0 0.0.0.255
PowerConnect(config)#route-map bgp4 permit 1
PowerConnect(config-routemap bgp4)#match ip address 1
PowerConnect(config-routemap bgp4)#set metric-type internal
The first command configures an ACL that matches on routes with destination network
192.168.9.0. The remaining commands configure a route map that matches on the destination
network in ACL 1, then sets the metric type for those routes to the same value as the IGP metric of
the BGP4 next-hop route.
Syntax: set metric-type internal
Setting the next hop of a BGP4 route
To set the next hop address of a BGP4 route to a neighbor address, enter commands such as the
following.
PowerConnect(config)#route-map bgp5 permit 1
PowerConnect(config-routemap bgp5)#match ip address 1
PowerConnect(config-routemap bgp5)#set ip next-hop peer-address