Dell FCX624-S Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 1155
53-1002266-01
Setting up local user accounts
32
Users are locked out (disabled) if they fail to login after three attempts. This feature is
automatically enabled. Use the disable-on-login-failure command to change the number of
login attempts (up to 10) before users are locked out.
The following rules are disabled by default:
Enhanced user password combination requirements
User password masking
Quarterly updates of user passwords
You can configure the system to store up to 15 previously configured passwords for each user.
You can use the disable-on-login-failure command to change the number of login attempts (up
to 10) before users are locked out.
A password can now be set to expire.
Enabling enhanced user password combination requirements
When strict password enforcement is enabled on the Dell PowerConnect device, you must enter a
minimum of eight characters containing the following combinations when you create an enable and
a user password:
At least two upper case characters
At least two lower case characters
At least two numeric characters
At least two special characters
NOTE
Password minimum and combination requirements are strictly enforced.
Use the enable strict-password-enforcement command to enable the password security feature.
PowerConnect(config)#enable strict-password-enforcement
Syntax: [no] enable strict-password-enforcement
This feature is disabled by default.
The following security upgrades apply to the enable strict-password-enforcement command:
Passwords must not share four or more concurrent characters with any other password
configured on the router. If the user tries to create a password with four or more concurrent
characters, the following error message will be returned.
Error - The substring <str> within the password has been used earlier, please
choose a different password.
For example, the previous password was Ma!i4aYa&, the user cannot use any of the following
as his or her new password:
Ma!imai$D because “Mail” were used consecutively in the previous password
&3B9aYa& because “aYa&” were used consecutively in the previous password
i4aYEv#8 because “i4aY“ were used consecutively in the previous password
If the user tries to configure a password that was previously used, the Local User Account
configuration will not be allowed and the following message will be displayed.
This password was used earlier for same or different user, please choose a
different password.