Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 1251
53-1002266-01
Displaying 802.1X information
34
Clearing 802.1X statistics
You can clear the 802.1X statistics counters on all interfaces at once, on individual interfaces, or
on a range of interfaces.
For example, to clear the 802.1X statistics counters on all interfaces on the device, enter the
following command.
PowerConnect#clear dot1x statistics all
Syntax: clear dot1x statistics all
To clear the 802.1X statistics counters on interface e 3/11, enter the following command.
PowerConnect#clear dot1x statistics e 3/11
Syntax: clear dot1x statistics ethernet <port>
Specify the <port> variable in the following formats:
• PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
Displaying dynamically assigned VLAN information
The show interface command displays the VLAN to which an 802.1X-enabled port has been
dynamically assigned, as well as the port from which it was moved (that is, the port default VLAN).
The following example of the show interface command indicates the port dynamically assigned
VLAN. Information about the dynamically assigned VLAN is shown in bold type.
Last EAPOL Source The source MAC address in the last EAPOL frame received on the
port.
TX EAPOL Total The total number of EAPOL frames transmitted on the port.
TX EAP Req/Id The number of EAP-Request/Identity frames transmitted on the port.
TX EAP Req other than Req/Id The number of EAP-Request frames transmitted on the port that
were not EAP-Request/Identity frames.
TABLE 214 Output from the show dot1x statistics command (Continued)
This field... Displays...