Filter
Top Products
1298 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying multi-device port authentication information
36
Displaying the MAC authentication table for PowerConnect B-Series
FCX devices
For PowerConnect B-Series FCX devices, there are three commands you can use to display MAC
authentication information:
• show table <mac address>
• show table allowed-mac
• show table denied-mac
This section describes the output for these commands.
To display MAC authentication information for FCX devices, enter the show table <mac address>
command as shown.
PowerConnect#show table 0000.0010.1002
Syntax: show table <mac address>
The <mac address> variable is the specified MAC address.
Output from this command resembles the following:
PowerConnect#show table 0000.0010.1002
-------------------------------------------------------------------------------
MAC Address Port Vlan Authenticated Time Age dot1x
-------------------------------------------------------------------------------
0000.0010.1002 2/1/48 2 Yes 00d00h30m57s Ena Dis
PowerConnect#
To display the table of allowed (authenticated) mac addresses enter the show table allowed-mac
command as shown.
Syntax: show table allowed-mac
Output from this command resembles the following:
MAC Address The MAC addresses learned on the port. If the packet for which multi-device
port authentication was performed also contained an IP address, then the IP
address is displayed as well.
RADIUS Server The IP address of the RADIUS server used for authenticating the MAC
addresses.
Authenticated Whether the MAC address has been authenticated by the RADIUS server.
Time The time at which the MAC address was authenticated. If the clock is set on the
Dell PowerConnect device, then the actual date and time are displayed. If the
clock has not been set, then the time is displayed relative to when the device
was last restarted.
Age The age of the MAC address entry in the authenticated MAC address list.
Dot1x Indicated if 802.1X authentication is enabled or disabled for the MAC address
TABLE 230 Output from the show auth-mac-addresses detailed command (Continued)
This field... Displays...