Filter
Top Products
124 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Managing your IronStack
5
CLI command syntax
CLI syntax that refers to stack units must contain all of the following parameters:
<stack-unit>/<slotnum>/<portnum>
• <stack-unit> - If the device is operating as a standalone, the stack-unit will be 0 or 1. Stack IDs
can be 0 or any number from 1 through 8.
• <slotnum> - Refers to a specific group of ports on each device.
• <portnum>- A valid port number. You can list all of the ports individually, use the keyword to to
specify ranges of ports, or a combination of both. To apply the configuration to all ports on the
device, use the keyword all in
IronStack CLI commands
CLI commands specific to stacking are listed in Table 23, with a link to the description for each
command. For more information about CLI commands and syntax conventions, refer to Chapter 1,
“Getting Familiar with Management Applications”.
TABLE 23 Stacking CLI commands
Command Description location...
copy flash flash “Copying the flash image to a stack unit from the Active Controller” on
page 126
clear stack ipc “Troubleshooting an unsuccessful stack build” on page 152
cx4-10g “Changing PowerConnect B-Series FCX-S and CX4 ports from 16 Gbps to 10
Gbps” on page 110
kill console “Configuring TACACS/TACACS+ for devices in a Dell IronStack” on page 1165
priority “Changing the priority of a stack unit” on page 123
rconsole “Logging in through the console port” on page 118
reload stack unit “Reloading a stack unit” on page 126
show chassis “Displaying chassis information” on page 133
show flash “Displaying flash information” on page 131
show memory “Displaying memory information” on page 132
show module “Displaying stack module information” on page 134
show running-config “Displaying running configuration information” on page 143
show stack “Displaying stack information” on page 135
show stack detail “Displaying stack information” on page 135
show stack flash “Displaying stack flash information” on page 137
show stack ipc “Troubleshooting an unsuccessful stack build” on page 152
show stack neighbors “Displaying stack neighbors” on page 142
show stack resource “Displaying stack information” on page 135
show stack rel-ipc stats “Displaying stack rel-IPC statistics” on page 138
show stack rel-ipc stats unit # “Displaying stack rel-IPC statistics for a specific stack unit” on page 141
show stack stack-port “Displaying stack port information” on page 143