Dell FCX624-S Laptop User Manual


  Open as PDF
of 1494
 
136 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Managing your IronStack
5
The show stack command displays general information about an IronStack, for all members, for a
specified member, and with additional detail if required.
The following output covers the entire stack.
PowerConnect(config)# show stack
alone: standalone, D: dynamic config, S: static config
ID Type Role Mac Address Pri State Comment
1 S FCX648 active 0012.f2eb.a900 130 local Ready
2 S FCX648 standby 00f0.424f.4243 0 remote Ready
3 S FCX624 member 00e0.5201.0100 0 remote Ready
4 S FCX624 member 0000.0000.0000 0 reserved
If you add a stack member ID, output is displayed for that member only.
PowerConnect# show stack 1
ID Type Role Mac Address Prio State Comment
1 S FCX648 active 0012.f2eb.a900 130 local Ready
PowerConnect# show stack 2
ID Type Role Mac Address Prio State Comment
2 S FCX648 standby 00f0.424f.4243 0 remote Ready, member after reload
PowerConnect#show stack 3
ID Type Role Mac Address Prio State Comment
3 S FCX624 member 00f0.424f.4243 0 remote Ready
If you add detail to the show stack command, output resembles the following.
PowerConnect(config)# show stack detail
ID Type Role Mac Address Prio State Comment
1 S FCX624 member 00e0.5201.4000 0 remote Ready
2 S FCX624 member 00e0.5205.0000 0 remote Ready
3 S FCX624 member 001b.ed5e.c480 0 remote Ready
4 S FCX624 active 001b.ed5e.ac00 128 local Ready
5 S FCX624 standby 001b.ed5d.a180 0 remote Ready
6 S FCX624 member 00e0.5200.3000 0 remote Ready
7 S FCX624 member 00e0.4444.0000 0 remote Ready
8 S FCX624 member 0012.f2eb.d540 0 remote Ready
Stack Port Status Neighbors
ID Stack-port1 Stack-port2 Stack-port1 Stack-port2
1 up (1/2/1) up (1/2/2) 3 6
2 up (2/2/1) up (2/2/2) 5 3
3 up (3/2/1) up (3/3/1) 2 1
4 up (4/2/1) up (4/3/1) 7 8
5 up (5/2/1) up (5/3/1) 8 2
6 up (6/2/1) up (6/3/1) 1 7
7 up (7/2/1) up (7/3/1) 6 4
8 up (8/2/1) up (8/3/1) 4 5
Syntax: show stack <stack-unit> | <detail>
Table 29 describes the fields displayed by the show stack command.