Dell FCX624-S Laptop User Manual


  Open as PDF
of 1494
 
PowerConnect B-Series FCX Configuration Guide 321
53-1002266-01
Displaying and modifying system parameter default settings
9
Syntax: lock-address ethernet [<port> [addr-count <num>]
Specify the <port> variable in the following formats:
PowerConnect B-Series FCX stackable switches – <stack-unit/slotnum/portnum>
The <num> parameter is a value from 1 – 2048.
Displaying and modifying system parameter default settings
Dell PowerConnect devices have default table sizes for the system parameters shown in the
following display outputs. The table sizes determine the maximum number of entries the tables can
hold. You can adjust individual table sizes to accommodate your configuration needs.
The tables you can configure, as well as the default values and valid ranges for each table, differ
depending on the Dell PowerConnect device you are configuring. To display the adjustable tables
on your Dell PowerConnect device, use the show default values command. The following shows
example outputs.
Configuration considerations
Changing the table size for a parameter reconfigures the device memory. Whenever you
reconfigure the memory on a Dell PowerConnect device, you must save the change to the
startup-config file, then reload the software to place the change into effect.
Configurable tables and their defaults and maximum values differ on Dell PowerConnect IPv4
devices versus IPv6-capable devices.
For more information about Layer 3 system parameter limits, refer to “Modifying and displaying
layer 3 system parameter limits” on page 625.
Displaying system parameter default values
To display the configurable tables and their defaults and maximum values, enter the show default
values command at any level of the CLI.