Filter
Top Products
516 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying GVRP information
14
To display detailed GVRP information for an individual port, enter a command such as the following.
GVRP Join Timer The value of the Join timer.
NOTE: For descriptions of the Join, Leave, and Leaveall timers or to change the
timers, refer to “Changing the GVRP timers” on page 512.
GVRP Leave Timer The value of the Leave timer.
GVRP Leave-all Timer The value of the Leaveall timer.
Configuration that is being used The configuration commands used to enable GVRP on individual ports. If GVRP
learning or advertising is disabled on a port, this information also is displayed.
Spanning Tree The type of STP enabled on the device.
NOTE: The current release supports GVRP only with Single STP.
Dropped Packets Count The number of GVRP packets that the device has dropped. A GVRP packet can
be dropped for either of the following reasons:
• GVRP packets are received on a port on which GVRP is not enabled.
NOTE: If GVRP support is not globally enabled, the device does not drop the
GVRP packets but instead forwards them at Layer 2.
• GVRP packets are received with an invalid GARP Protocol ID. The protocol
ID must always be 0x0001.
Number of VLANs in the GVRP
Database
The number of VLANs in the GVRP database.
NOTE: This number includes the default VLAN (1), the GVRP base VLAN
(4093), and the single STP VLAN (4094). These VLANs are not
advertised by GVRP but are maintained as “Registration Forbidden”.
Maximum Number of VLANs that
can be present
The maximum number of VLANs that can be configured on the device. This
number includes statically configured VLANs, VLANs learned through GVRP,
and VLANs 1, 4093, and 4094.
To change the maximum number of VLANs the device can have, use the
system-max vlan <num> command. Refer to “Displaying and modifying system
parameter default settings” on page 321.
TABLE 82 CLI display of summary GVRP information (Continued)
This field... Displays...