Filter
Top Products
PowerConnect B-Series FCX Configuration Guide 755
53-1002266-01
PIM Sparse
25
NOTE
When the product of the number of active PIM interfaces multiplied by the number of multicast
streams exceeds the total number of MLL, the CLI displays the message, “MLL pool out of memory”.
NOTE
The total number of MLL available changes according to the hardware configuration.
Displaying candidate RP information
To display candidate RP information, enter the following command at any CLI level.
This example show information displayed on a Layer 3 Switch that is a candidate RP. The following
example shows the message displayed on a Layer 3 Switch that is not a candidate RP.
PowerConnect#show ip pim rp-candidate
This system is not a Candidate-RP.
Syntax: show ip pim rp-candidate
This display shows the following information.
Displaying RP-to-group mappings
To display RP-to-group-mappings, enter the following command at any CLI level.
PowerConnect#show ip pim rp-map
Number of group-to-RP mappings: 6
Group address RP address
-------------------------------
TABLE 131 Output of show ip pim rp-candidate
This field... Displays...
Candidate-RP-advertisement
in
Indicates how many seconds will pass before the BSR sends its next RP
message.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
RP Indicates the IP address of the Rendezvous Point (RP).
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
group prefixes Indicates the multicast groups for which the RP listed by the previous field is a
candidate RP.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
Candidate-RP-advertisement
period
Indicates how frequently the BSR sends candidate RP advertisement messages.
NOTE: This field appears only if this Layer 3 Switch is a candidate RP.
PowerConnect#show ip pim rp-candidate
Next Candidate-RP-advertisement in 00:00:10
RP: 207.95.7.1
group prefixes:
224.0.0.0 / 4
Candidate-RP-advertisement period: 60