Filter
Top Products
870 PowerConnect B-Series FCX Configuration Guide
53-1002266-01
Displaying IP configuration information and statistics
26
• IP interfaces – refer to “Displaying IP interface information” on page 873.
• ARP entries – refer to “Displaying ARP entries” on page 874.
• Static ARP entries – refer to “Displaying ARP entries” on page 874.
• IP forwarding cache – refer to “Displaying the forwarding cache” on page 877.
• IP route table – refer to “Displaying the IP route table” on page 878.
• IP traffic statistics – refer to “Displaying IP traffic statistics” on page 881.
The following sections describe how to display this information.
In addition to the information described below, you can display the following IP information. This
information is described in other parts of this guide:
• RIP
• OSPF
• BGP4
• DVMRP
• PIM
• VRRP or VRRPE
Displaying global IP configuration information
To display IP configuration information, enter the following command at any CLI level.
Syntax: show ip
NOTE
This command has additional options, which are explained in other sections in this guide, including
the sections following this one.
This display shows the following information.
PowerConnect# show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 207.95.11.128
enabled : UDP-Broadcast-Forwarding IRDP Proxy-ARP RARP OSPF
disabled: BGP4 Load-Sharing RIP DVMRP FSRP VRRP
Static Routes
Index IP Address Subnet Mask Next Hop Router Metric Distance
1 0.0.0.0 0.0.0.0 209.157.23.2 1 1
Policies
Index Action Source Destination Protocol Port Operator
1 deny 209.157.22.34 209.157.22.26 tcp http =
64 permit any any