Filter
Top Products
162 Adding and Replacing Parts
a
Align the computer cover with the tabs on the computer base.
b
Pivot the cover down and gently press the cover until it clicks into
place.
c
Ensure that the cover is locked. If not, repeat all of step 3.
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
4
Connect your computer and devices to electrical outlets, and turn them
on.
5
After you open and close the cover, the chassis intrusion detector, if
enabled, causes the following message to appear on the screen at the next
computer start-up:
ALERT! Cover was previously removed.
6
Reset the chassis intrusion detector by changing Intrusion Alert to
Enabled or Enabled-Silent. See "Resetting the Chassis Intrusion Detector"
on page 76.
1 computer cover 2 computer base
2
1