Filter
Top Products
Adding and Replacing Parts 213
3
Remove the computer cover (see "Removing the Computer Cover" on
page 153).
NOTICE: If only one hard drive is to be installed, it should be connected to the
SATA0 connector on the system board.
4
Disconnect the hard drive power cable from the hard drive that you are
removing.
5
Disconnect the data cable from the hard drive that you are removing.
Do not disconnect the data cable for an uninstalled hard drive from the
system board.
6
Rotate the hard-drive carrier out of the computer (see "Rotating the Hard-
Drive Carrier Back into the Computer" on page 159).
7
Press the blue tabs on each side of the hard-drive bracket toward each
other and slide the drive up and out of the hard-drive bay.
1 data connector 2 power connector
3 hard drive
3
1
2