Dell NX046 Personal Computer User Manual


 
228 Adding and Replacing Parts
Then, if metal shields are present in your computer (see "About the Metal
Shields Present in Some Drive Configurations" on page 207), install the
5.25-inch metal shield in its place: align its screws in the metal rails and
push the shield back until it clicks into place.
12
If you are installing another drive in the optical drive bay, see the
appropriate procedure.
13
Replace the desktop drive retention insert and fold down its handle.
14
Reinstall the drive panel (see "Replacing the Drive Panel" on page 237).
15
Replace the computer cover (see "Replacing the Computer Cover" on
page 161).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
16
Connect the computer and devices to electrical outlets, and turn them on.
Installing an Optional Third SATA Hard Drive (Desktop Only)
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the
Product Information Guide
.
CAUTION: To guard against electrical shock, always unplug your computer from
the electrical outlet before removing the cover.
NOTICE: In order to install a third SATA hard drive in one of the 5.25-inch drive
bays, it must be installed in the provided hard-drive carrier, then installed into the
lower 5.25-inch drive bay.
1
If you are installing a new drive, unpack the drive and prepare it for
installation.
Check the documentation for the drive to verify that it is configured for
your computer.
2
Follow the procedures in "Before You Begin" on page 151.
3
Remove the computer cover (see "Removing the Computer Cover" on
page 153).
4
Remove the drive panel (see "Removing the Drive Panel" on page 233).
5
Pull the desktop drive retention insert out by the handle and set it aside in
a safe place.